Your cart
Please Wait

Wood Application

Print Application
Wood LOVES Durabak - it swells up and becomes super tough with Durabak!
Applying Durabak on Wood is simple, if you follow these instructions carefully it will never come off!

Equipment

  • stipple roller sleeves per gallon (Included with purchase of textured gallon) or short nap roller, like a 3/16” mohair or similar for a smooth application.
  • 60 grit Sandpaper
  • Xylene (Xylol) OR Solvide (in CA or UT)
  • Stir stick or electric paint mixer
  • Roller Tray
  • Cloth or sturdy cotton rag
  • Paint Gloves
  • Household non-chlorinated detergent, like Spic n Span
  • 3M Blue tape (Optional)
  • Paint Respirator (Optional)

Surface Prep

  • Clean the surface thoroughly, with a non-chlorinated household detergent
  • Rough up the surface with 60 grit sandpaper
  • Wipe down the surface with xylene or Solvide on a cloth and once completely dry, apply the Durabak.
  • For the first coat use smooth Durabak, as rubber granules will not be absorbed into the wood.

Application Process

  • Do not open can until surface is prepped and ready to go.
  • Then open can and stir well.
  • Pour a portion into a roller tray and begin application.
  • Roll on first coat using Durabak stipple roller sleeve.
  • Use a paint brush in corners and hard to reach areas.
  • Stir occasionally while working with the product.
  • Keep lid on can while not in use.

Coverage

Wood can be very absorbent, and usually requires an additional coat for a full Durabak finish.

1 gallon of smooth Durabak covers roughly 50 square feet in a 3 coat application.

1 gallon of textured Durabak covers approximately 40 square feet in a 3 coat application.

Good to Know

  • Durabak begins to cure with exposure to air, so minimize exposure to air while working with it. Durabak is MOISTURE CURED so in High Humiidity the work time and dry time will be substantially shorter.
  • The consistency of the Durabak should be runny, as it’s self leveling. If it’s thicker, you can add up to 15% xylene to thin it. It should be mixable after adding the xylene and back to a runny form. If it’s pasty and thick, DO NOT APPLY, rather reach out to us for assistance.
  • You will have a few hours of work time once the can is opened (3 to 5 hours normally).
  • A second coat can be applied using a stipple roller sleeve after 1-2 hours, once the first coat is touch dry.
  • After second coat is applied allow 24 hours before walking on it. Complete cure is about 5 or 6 days, so no heavy use until then.
  • When applying Durabak it is important to ensure that each coat does not get too thick. If Durabak is applied in a coat that is too heavy it will trap the curing gasses and leave pinholes which will eventually lead to discoloration in the Durabak.

  • Be sure to apply moderately thin coats of the Durabak and as a guide you should be getting coverage similar to what is laid out above.

Additional Tips

  • Temp should ideally be 60 degrees or above for the application, and above 40% humidity.
  • Xylene should be applied immediately to clean up any misapplied Durabak.
  • If taping off, use 3M Blue tape and remove immediately after second coat is applied at taped off edges, then continue with general application of the second coat.
×